View Single Post
Old December 17, 2012, 09:20 AM   #6
solocam72
Senior Member
 
Join Date: December 15, 2012
Location: Idaho
Posts: 221
I'm talking a tiny amount of material, a few thousandths, I havnt calipered my hair on my head but I would say that was about the amount of material removed from the top of the shellholder, then I readjusted the die by unlocking the large lock ring and screwing the die body down til it contacted the top of the shellholder about a quarter turn past this (maybe a little less) then set the lock ring, the shellholder slightly cams the bottom of the die at the top of the press stroke, by removing that TINY bit of material off the top of the shell holder it bumped the shoulder of the case back just enough for them to chamber perfectly. All I can say is it worked fabulous!
solocam72 is offline  
 
Page generated in 0.05970 seconds with 7 queries