Thread: Excessive wear?
View Single Post
Old December 15, 2012, 01:00 PM   #7
sltm1
Senior Member
 
Join Date: February 25, 2009
Location: Idaho
Posts: 303
Try this, take the barrel off and the cylinder out, place the barrel back on the arbor turned sideways and push it towards the receiver. The base of the barrel should be even with the receiver base when you can no longer push it forward, if it goes further and overlaps, then the arbor isn't seated properly, the tip must be shimmed to get the barrel to stop dead even with the receiver.
sltm1 is offline  
 
Page generated in 0.04136 seconds with 7 queries