View Single Post
Old December 15, 2012, 12:50 PM   #32
RC20
Senior Member
 
Join Date: April 10, 2008
Location: Alaska
Posts: 2,017
Another solution might be to load them, then put an identical load block over the top and secure them.

Rubber bands them together, put in a bag and carry to the garage. You would get a pretty good seal from any moisture and short trip and little or no temp drop during the crossing.

I like the idea of a hand pre seat better as its more solid and then finish seating and the crimp on the press in the garage.
RC20 is offline  
 
Page generated in 0.04673 seconds with 7 queries