View Single Post
Old December 12, 2012, 10:39 AM   #22
SL1
Senior Member
 
Join Date: November 8, 2007
Posts: 2,001
Another potential worry for folks who just keep pouring brass, bullets and powder in to their respective bins on progressive presses, without inspecting each individual component?

Would it be possible for a 9mm bullet to end-up in a larger capacity case, UNDER the proper bullet? Probably not a 9mm under a .40 cal in a .40 S&W case, but how about a 10 mm case, or a .45 ACP case, or a .41, .44 or .45 revolver cartridge case?

If that can happen, it will probably raise pressure considerably simply by subtantially reducing powder space.

SL1
SL1 is offline  
 
Page generated in 0.04255 seconds with 7 queries