View Single Post
Old December 11, 2012, 10:03 PM   #3
drail
Junior member
 
Join Date: February 2, 2008
Posts: 3,150
Just keep a thin coat of Breakfree CLP or Eezox on it. I use a small stenciling brush to put it on and then wipe any excess off with a rag. The whole gun should only take 4 or 5 drops of oil when applied with a brush. The brush allows you to get right up to the grips and will get oil into the nooks and crannies. All of my blued guns look just like they did 20 years ago. If you use a holster very much the bluing will wear away. Bluing is very thin and not very hard. But it is still the best looking finish to me.
drail is offline  
 
Page generated in 0.04248 seconds with 7 queries