View Single Post
Old December 11, 2012, 06:59 PM   #9
tkglazie
Senior Member
 
Join Date: December 3, 2011
Posts: 558
How much time should I reasonably expect to spend in a typical session? That is, once I have learned the basics, how long does it take to setup the pot outside, warm the pot, get into production mode (get things at the right temp that you arent molding rejects), crank out a few hundred bullets and then cool everything down to the point where you can pack up and go inside for the sizing/lubing etc.

The reason I ask is I am considering doing my casting at my local sportsmans club instead of the duplex I live in. The club is not heavily used, is very close by and I have good access to it. I could easily setup on a portable table with access to electric where no one will bother me.
tkglazie is offline  
 
Page generated in 0.04111 seconds with 7 queries