View Single Post
Old December 11, 2012, 05:06 PM   #3
Doc Hoy
Senior Member
 
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 4,598
Yep

Willie,

Yes, I have had the barrel in the lathe just to check the fit.

I will have to shim the barrel at the back of the lathe spindle. I figure to make the shims from brass stock.


Thanks for the response.

This present sight is not dovetailed to the barrel and I am fairly certain I will apply the new sight the same way.

I am seeking a foolproof way of locating the new sight in proper alignment.

Any advice is much appreciated.
__________________
Doc

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
 
Page generated in 0.04236 seconds with 7 queries