View Single Post
Old December 10, 2012, 01:21 PM   #4
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 315
If you are using a SS press, then it make sence to economize on dies since you wil need to adjust them every time you preform a different step. If you are using a progressive press, you probably want to adjust the dies once and leave them, so trying to save a few bucks is not worth it.

In .380 amd other small case ammo, I would avoid Hornady dies. Unfortuately, I have crushed a few cases in my day and the one constant is that these usually happen with Hornady sizing dies. I think their tapper used to direct the case in to the die is extreme and this causes issues, at least for me.
rajbcpa is offline  
 
Page generated in 0.06135 seconds with 7 queries