View Single Post
Old December 10, 2012, 12:07 PM   #4
Aguila Blanca
Senior Member
 
Join Date: September 25, 2008
Location: CONUS
Posts: 6,324
I've never worked on a Ruger SA revolver but, based on other revolvers I have seen the inner workings of, I have to ask "Why do you need to remove the hammer pin?" If you remove the hammer pin, the hammer falls out. It that necessary to change the hammer spring? I've not encountered any revolver that hasn't allowed me to remove the hammer spring with the hammer in place.
Aguila Blanca is offline  
 
Page generated in 0.04559 seconds with 7 queries