View Single Post
Old December 10, 2012, 07:38 AM   #13
jehu
Senior Member
 
Join Date: March 21, 2005
Posts: 348
IMO you don't need a torque wrench and I've never heared of anyone useing one to mount a scope. Just line up the reticle so it looks straight to you when you mount the rifle and make sure you have the best position back or forward that is comfortable and takes advantage of you scopes eye rielef then tighten down your screws evenly and I would not use loctite on the screws as it could make it very difficult to undo if need be. The old trick is use finger nail polish which will not allow screws to loosen but will allow you to take screws out eaisier if needed.
jehu is offline  
 
Page generated in 0.04807 seconds with 7 queries