View Single Post
Old December 8, 2012, 06:21 PM   #4
datboiryan
Member
 
Join Date: July 31, 2011
Posts: 20
Well I just got it out.

Got a fixed blade knife and wrapped the blade with some duct tape to not scratch it out. Since the bolt wasn't fully locked into place, I stuck the knife into the magwell and pried it loose. There wasn't hardly any force needed and the bullet came out with it.

I don't know what caused it yet but will report back with my findings. I may not have set up the resizing die correctly. It was the first time using the new ones so that is my guess right now.
datboiryan is offline  
 
Page generated in 0.04920 seconds with 7 queries