View Single Post
Old December 8, 2012, 01:07 PM   #4
WIN1886
Senior Member
 
Join Date: March 25, 2012
Location: Minnesota
Posts: 566
Actually , I did remove the magazine disconnect and yes , the trigger pull does feel smoother (not as gritty) and a bit lighter in pull...however , I'm having second thoughts about the removal of it for liability reasons if for some very remote possibility of an accidental discharge which this could become an issue ! I've been checking out some out sources like Cylinder & Slide that claim to reduce the trigger pull to about 5 lbs with the disconnect left intact...plus they can install the non-bite type hammer I'm looking for as well and other parts & services to enhance the performance of the BHP !
WIN1886 is offline  
 
Page generated in 0.03998 seconds with 7 queries