The Firing Line Forums - View Single Post

PetahW · December 8, 2012, 12:34 PM

The ends don't need to be "bent flat" - just drop the spring down into the mag tube against the inside of the cupped follower, compress the forward/free end into the tube & install the end cap.

.

December 8, 2012, 12:34 PM	#3
PetahW Senior Member Join Date: September 19, 2008 Posts: 3,273	The ends don't need to be "bent flat" - just drop the spring down into the mag tube against the inside of the cupped follower, compress the forward/free end into the tube & install the end cap. .