View Single Post
Old December 7, 2012, 03:19 PM   #1
WIN1886
Senior Member
 
Join Date: March 25, 2012
Location: Minnesota
Posts: 573
Custom carry trigger job and barrel work on BHP question ?

I've been thinking of sending my Browning Hi Power in for a custom carry trigger job ( leaving the magazine disconnect installed ) and am wondering if anyone here has had this done ? Who would you recommend and how did it turn out ? I would like to replace the stock hammer with a non-bite hammer as well ! Barrel work would just be polishing feed ramp and such , thanks !
WIN1886 is offline  
 
Page generated in 0.04586 seconds with 7 queries