View Single Post
Old December 7, 2012, 11:30 AM   #1
cogito
Member
 
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
Raise front sight on Buckmark Hunter?

Howdie,

I just bought a Browning Buckmark Hunter, which I love -- except that it is shooting high. I put Williams firesights on the rear, and the front sight is already quite high to accommodate the raised rib.

I've lowered the rear sight as low as it can possibly go, but I'm still shooting high... same data confirmed by my bore laser.

Does anyone know of a fiber optic front sight that would be compatible and is still higher than the standard Hunter sight?

Or, any strategy so that the front sight could be about 1/32" higher? I'm not sure anything short of making a small riser will work. I suppose I could cut a piece of plastic to size, drill a hole, add a pin, etc..

Maybe, I'll buy a cheap hi-viz front sight and reshape it into the riser.

Opinions?
cogito is offline  
 
Page generated in 0.04239 seconds with 7 queries