View Single Post
Old December 6, 2012, 08:53 PM   #14
jhabers
Junior Member
 
Join Date: September 24, 2012
Posts: 7
OK, I "fixed" my probelm. I know this is not the right way to do it and I'm sure someone will say that I messed something up but its rock solid consistent now with reading weights.

Whats I did was I noticed the "agate grooves" would pivot on the frame a bit, so I took a piece of paper and folded it once and then cut a tiny square out of it. I put the piece on one side of the "agate groove" piece so that it would fit snug in the frame so it would not move at all.

I know that this is not the way that the scale is designed to work but the scale works rock solid now

Jon
jhabers is offline  
 
Page generated in 0.04237 seconds with 7 queries