View Single Post
Old December 6, 2012, 01:01 PM   #9
Ole man 52
Member
 
Join Date: May 16, 2012
Location: Louisville,Ky
Posts: 38
Thanks for the tips on primer tubes. Gonna give that a try. I knew that I should of bought the Hornandy dies. I had the lee dies on hand and was trying to save a few dollars because of Christmas. I will purchase the Hornandy dies and a 45 shell plate after the holidays. I was still able to make a lot of shells in a short period of time. My wife primed them on my SS press and I ran them thru the progressive. This kind of defeats the purpose of the press but we were able to kick a couple hundred out in a matter of minutes instead of hours. I hope with your suggestions that I can get the priming system to work as advertised.
Ole man 52 is offline  
 
Page generated in 0.04853 seconds with 7 queries