View Single Post
Old December 5, 2012, 03:19 PM   #1
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 315
Ever have bullet lube build up and push a bullet deep into the case?

I was using some lead cast bullets (FN) with the blue lube and one of the press pulls felt a tad strange. When I released the handle there was a ton of blue bullet lube on one case (at the bullet head) and the completed round was clearly shorter than the rest.

Apparently, a bunch of blue bullet lube accumulated in the die and then pushed the bullet deep into the case.

How do you prevent this from happening? Should I do a plunk test on this entire batch or measure each round - about 250?

My usual procedure is to plunk the first 10 or so after any die adjustment and at the start of every new batch...

thx..
rajbcpa is offline  
 
Page generated in 0.04786 seconds with 7 queries