View Single Post
Old December 3, 2012, 08:24 PM   #7
243winxb
Senior Member
 
Join Date: July 26, 2011
Posts: 921
Not from a Lee tool, but can look the same. Here was the cause of my separations. Ammo loaded in the late 80's without the use of a comparitor or case gage. Each station of the shell plate was a different thickness. If the FL die was set using the station in the photo, some brass would separate on firing. Nothing in the instructions with the loader back then. Now they tell you to use a case gage.
243winxb is offline  
 
Page generated in 0.04383 seconds with 7 queries