View Single Post
Old December 3, 2012, 07:51 PM   #11
hodaka
Senior Member
 
Join Date: April 23, 2006
Location: South Texas
Posts: 1,851
jackpine, I think you are overanalyzing it. It is not that complicated to cut down the 9mm in order for it to work in the Mak. Many more radical alterations work just fine. This is a simple one. In my uses I really can't tell the difference in function or accuracy in either the cut Luger brass or commercial Mak brass. This is a low pressure, blowback pistol known for digesting anything. I rarely use duct tape.
hodaka is offline  
 
Page generated in 0.05016 seconds with 7 queries