View Single Post
Old December 3, 2012, 05:42 PM   #9
James K
Staff
 
Join Date: March 17, 1999
Posts: 18,670
For small parts where strength or hardness is not a factor, just heating the part with a torch or on a hotplate is perfectly OK. You just have to be sure to get it safely away from the heat when it is at the right color. (A friend - not me, honest - would also advise not to drop a hot part on the linoleum floor of the kitchen unless you want to spend a lot of money on a new floor.)

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.04010 seconds with 7 queries