View Single Post
Old December 2, 2012, 10:20 PM   #20
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 2,946
Quote:
I measured the width right at the end of the case and got .473. If that is out of the ballpark, would cranking down my crimper die about another 1/4 turn help?
The single greatest problem causing the 45ACP's slide to fail closing that last 1/10" as you describe, is the mouth diameter.

Turn the die down whatever it takes to get 0.469 - 0.470 and see if that doesn't solve the problem.
mehavey is offline  
 
Page generated in 0.05631 seconds with 7 queries