View Single Post
Old December 2, 2012, 09:03 PM   #2
1stmar
Senior Member
 
Join Date: March 21, 2012
Location: Connecticut
Posts: 1,075
Fusion, first make sure all the conditions are right, solid level surface, eye level, no draft and clean the hinge point. Do you have weight checks? I zero mine then check the calibration with several weights varying from .2 to 20gr. And then back to zero. I also always tap the beam and let it bounce to make sure it "settles" correctly. It seems sometimes with small weights it "hangs" usually a little low.
1stmar is offline  
 
Page generated in 0.04308 seconds with 7 queries