View Single Post
Old December 2, 2012, 06:14 PM   #10
Gerry
Senior Member
 
Join Date: December 24, 2010
Location: Canada
Posts: 382
I always start off with my lead very hot with a cold mold to get perfect bullets right from the start. Then I turn it down after a few pours so that the lead cools while the mold heats up. If you keep the lead too hot, it will oxide much more quickly and cause all kinds of dross to form that will need to be fluxed back in more often.
Gerry is offline  
 
Page generated in 0.03847 seconds with 7 queries