Thread: ball powder?
View Single Post
Old December 2, 2012, 04:57 PM   #4
Crankgrinder
Senior Member
 
Join Date: July 24, 2011
Location: Texas
Posts: 715
thanks again folks, I believe it was on this forums i read a post stating ball powder was worse for top strap cutting in heavy loads once, but then if youre shooting very heavy loads you may experience some of that anyways so youre probably right there by all accounts. Lots of bad information out there, along with things that are just not known because either it hasnt been tested or there is no way to test it out. Ill look into some load data for these powders and perhaps try one.
Crankgrinder is offline  
 
Page generated in 0.04432 seconds with 7 queries