View Single Post
Old December 2, 2012, 01:51 PM   #3
weblance
Senior Member
 
Join Date: October 3, 2012
Posts: 654
Can you tell where its leading? Barrel, Cylinder or Forcing Cone? Reason I ask is I recently bought a 2" stainless 94. I ordered it and when it came, the cylinder machining was so badly done(drilled, but never factory polished)that I wanted it sent back to the distributor for another one. The shop refused and told me to send it to Taurus. Long story short, I decided to polish the cylinder myself, and have reduced the leading considerably. Just food for thought.
weblance is offline  
 
Page generated in 0.04926 seconds with 7 queries