View Single Post
Old December 2, 2012, 12:23 PM   #7
wogpotter
Senior Member
 
Join Date: September 27, 2004
Posts: 3,350
It depends on what caused the problem as much as how to fix it.

If its just the barrel & shroud incorretly gapped than yes. You use a .004 & a .002 feeler gauge (or the .006 one supplied if you have it) the barrel nut wrench, & one of the hex keys attached to the nut wrench (assuming the factory wrench). The gun is stripped to access the adjustment screw for the spring & set corrrectly first, then the barrel correctly inserted & gapped the shroud slipped on & the nut tightened.

But if the frame has been stretched by uber hot loads or something else then it's toast unfortunately.
__________________
Allan Quatermain: “Automatic rifles. Who in God's name has automatic rifles”?

Elderly Hunter: “That's dashed unsporting. Probably Belgium.”
wogpotter is offline  
 
Page generated in 0.04494 seconds with 7 queries