View Single Post
Old December 1, 2012, 09:41 PM   #9
red96ta
Member
 
Join Date: July 6, 2012
Posts: 50
I've pretty much chalked it up to 'stuff happens'. I followed all the 'rules' for safety and it still didn't get along well. Greased the ends, ampco nipples, RWS 1075 caps that fit well. The only thing I can figure may have happened was that the grease came out of the top of the cylinder...it's happened before. Perhaps it was dislodged and the next shot set them off. I hate to use lubed wads since it increases my per-shot cost, but it's a viable option if I make my own.
red96ta is offline  
 
Page generated in 0.04691 seconds with 7 queries