View Single Post
Old December 1, 2012, 08:43 PM   #11
loademwell
Senior Member
 
Join Date: November 6, 2012
Posts: 144
GOt an O.K. Pic to post. Hope you guys can help out.
All that these dies have on them (writing wise):
Bottom Right: 8MM
Bottom Left: 270
Upper Left: 8MM (Bullet seater is in it now. the extra Depriming tool on the upper right Does not fit)
Upper Middle: 15 (That is it!!! No other markings) Well, the decaper has 8MM on it on the top... But not the housing
Upper right: 2 78 (only on the end)

Thats about as much as I can tell ya....
Attached Images
File Type: jpg IMG_20121201_190812.jpg (230.3 KB, 44 views)

Last edited by loademwell; December 1, 2012 at 09:01 PM. Reason: pic.
loademwell is offline  
 
Page generated in 0.04195 seconds with 8 queries