Thread: New LCR Broken
View Single Post
Old December 1, 2012, 04:13 PM   #22
Nanuk
Senior Member
 
Join Date: January 2, 2005
Location: Where the deer and the antelope roam.
Posts: 1,709
Quote:
I was very disappointed by one of these earlier this year, which is sad, because I really wanted to like it.

My experience with the LCR was pretty negative, very tight chambers that were difficult to extract (same ammo shot through two j-frames worked fine) and a trigger that was light, but had a vague and very long reset,which often caused me to short stroke. In addition, it's a bit bulky and although it's made largely of plastic, it isn't much lighter than all aluminum revolvers.

I put about 100 rounds through one this summer and went back to my J-frame. A heavier trigger, sure, but, no short stroking issues to train around.

That is EXACTLY my experience with the gun. Had a 357 and WANTED to like it so bad. In the end I bought a 640 Pro and back to Smiths.....
__________________
My rifle and pistol are tools, I am the weapon.
Nanuk is offline  
 
Page generated in 0.04180 seconds with 7 queries