Thread: New LCR Broken
View Single Post
Old November 30, 2012, 10:12 PM   #11
testuser
Senior Member
 
Join Date: September 8, 2010
Posts: 495
I was very disappointed by one of these earlier this year, which is sad, because I really wanted to like it.

My experience with the LCR was pretty negative, very tight chambers that were difficult to extract (same ammo shot through two j-frames worked fine) and a trigger that was light, but had a vague and very long reset,which often caused me to short stroke. In addition, it's a bit bulky and although it's made largely of plastic, it isn't much lighter than all aluminum revolvers.

I put about 100 rounds through one this summer and went back to my J-frame. A heavier trigger, sure, but, no short stroking issues to train around.
testuser is offline  
 
Page generated in 0.04969 seconds with 7 queries