View Single Post
Old November 30, 2012, 04:27 PM   #4
Bill DeShivs
Senior Member
Join Date: April 7, 2006
Posts: 7,774
Take a small wad of 0000 steel wool, and very gently scrub it in a circular motion with your thumb until the remaining rust is gone. Make sure you clean the residual steel wool from the bore and action. You might plug the bore with a patch or piece of tissue first.
The chemical rust removers will remove the bluing-the steel wool won't.
Bill DeShivs, Master Cutler
Bill DeShivs is offline  
Page generated in 0.03654 seconds with 7 queries