View Single Post
Old November 30, 2012, 03:53 PM   #7
scsov509
Senior Member
 
Join Date: November 22, 2006
Posts: 758
I wouldn't worry too much about grease in the upper since its not going to hurt your function at all and will get cleaned out eventually anyway. You will want to lube the bolt and carrier well, paying special attention to the lugs and also the rails on the carrier. I also don't shoot anything new until I've cleaned out the chamber and bore to make sure there is nothing in there that can cause damage once you start running cartridges into the chamber and bullets down the bore. You'll also want to lube your fire control group as well, nothing liberal there but definitely want to make sure they've got at least a little lube on them.
scsov509 is offline  
 
Page generated in 0.04456 seconds with 7 queries