View Single Post
Old November 30, 2012, 02:02 AM   #1
Join Date: August 13, 2008
Location: California
Posts: 94
Rifle Bore Machining Marks ?

Recieved a new Wilson barrel from Brownells for my Mauser.
I can see machining marks in the bore, mostly on the lands, you can see it on the bottom land.
Wondering if it is going to copper foul easy or Lead up easy, want to shoot cast accurately
Normal or send it back ?

Today is my Best Day.
Lincoln, Ca.
Hylander is offline  
Page generated in 0.03392 seconds with 7 queries