View Single Post
Old November 29, 2012, 08:38 PM   #16
phorton
Junior Member
 
Join Date: May 29, 2011
Posts: 9
In this gun I am having to seat the bullets deep enough to get 3.221 c o a l , about like some factory loads I measured that gets me a little off the lands. I talked to Ty from Barnes bullets today and he recommended to go ahead and go up with my powder charge and compress the powder, I was a little uneasy to do that but I am gonna give it a try, I will measure the load immediately after seating the bullet and then remeasure after 15 or 20 minutes to make sure the powder is not pushing the bullet out per Ty's recommendation
phorton is offline  
 
Page generated in 0.04648 seconds with 7 queries