View Single Post
Old November 29, 2012, 05:07 PM   #6
grubbylabs
Senior Member
 
Join Date: October 11, 2009
Location: Hansen Idaho
Posts: 1,442
I started out with a cheap pot to smelt in. (thrift store)
#20 Lee bottom pour pot
2 lee molds tumble lube kind
push through sizing die for each bullet
turkey fryer for smelting.
some cheap ladles for use while smelting.

I think that is about it. Those two cavity molds from lee do not require a lot of pre heating.

I also bought the Lyman casting hand book. The hand book along with some quality time over at the castboolits forum helped my out quit a bit.
__________________
* (Swinging club) Whack! whack! whack! *

Nope, the old nag's still dead .
(Capt Charlie)
grubbylabs is offline  
 
Page generated in 0.04278 seconds with 7 queries