View Single Post
Old November 29, 2012, 02:33 AM   #4
mynameismud
Junior Member
 
Join Date: November 27, 2012
Posts: 4
As far as the trigger goes, I was thinking a much stiffer spring, however shorter pull to give the same weight. I thought it would give more of a "wall", but it would be a different feel than most DA pulls, and was wondering if that would jerk to much after the release. Also, having a shorter DA pull would give less slack to take up on the design I have in mind, so I thought that would be a plus too. Then again I could be way off base too.
mynameismud is offline  
 
Page generated in 0.04437 seconds with 7 queries