View Single Post
Old November 27, 2012, 11:48 PM   #1
grubbylabs
Senior Member
 
Join Date: October 11, 2009
Location: Hansen Idaho
Posts: 1,432
Interesting problem with Rifle bullets.

I just got a new set of RCBS dies for my 223 and I noticed that when seating the bullet the die is shaving off half the soft point. Very cleanly! Am I doing something wrong?


I raised an empty case and then screwed the die body in until i felt resistance. Then I put a soft point in and set the seating stem in pretty much the same way. lowered the seating stem a little at a time. The first few bullets did not have any problems. But the last few did.

Any ideas?
__________________
* (Swinging club) Whack! whack! whack! *

Nope, the old nag's still dead .
(Capt Charlie)

Last edited by grubbylabs; November 28, 2012 at 12:22 PM.
grubbylabs is offline  
 
Page generated in 0.04171 seconds with 7 queries