View Single Post
Old November 27, 2012, 08:35 PM   #1
Bob Wright
Senior Member
 
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 1,837
Work on the Hy Hunter.....

This is my new Hy Hunter trial fitted with a brass trigger guard:



The Hy Hunter mainspring screw would not fit the trigger guard, so ordered a Uberti replacement part. The Uberti screw almost fit. I went to my local hardware store and we tried various size nuts until one ran up on the screw, and found the thread was 10-24NC. So I bought a 10-24NC tap and chased the threads in the trigger guard. Also a brass Uberti backstrap had arrived and I have assembled the whole assembly. Needs some fitting and match polishing, but everything fits and the action works. Also need to make a pair of grips. Thinking of making a one piece style of grip. Will post more photos soon.

Bob Wright
Bob Wright is offline  
 
Page generated in 0.04286 seconds with 7 queries