View Single Post
Old November 27, 2012, 07:34 AM   #43
Magnum Wheel Man
Senior Member
 
Join Date: July 26, 2006
Location: Southern Minnesota
Posts: 8,446
my fabricator buddy needed to borrow a set of my hot rod tires for fitting on his car, so he was over & measured for my stainless bench top last night... ( it's a little complex, with the front being rolled over, & 1/2 of the left side. the other 1/2, the back, & the right side will fit flush to the wall... the left front corner will be welded where the 2 rolled over edges meet up...

might have my bench top done by this weekend ??? if I can come up with the $200.00 the stainless costs
__________________
In life you either make dust or eat dust...
Magnum Wheel Man is offline  
 
Page generated in 0.04379 seconds with 7 queries