View Single Post
Old November 25, 2012, 03:48 PM   #30
DASHZNT
Junior member
 
Join Date: July 13, 2012
Posts: 179
Well.. ive done all that you ask. I just cannot get a piece of brass resized to chamber with the bolt closed! The rifle chambers factory ammk and brass that was fired in it. But the ones that dont, thats the whole point of a resizing die, to bring it back to spec. I cannot get past the first step in reloading if the brass wont allow the bolt to close. Seating and crimp arent even on the agenda yet because the brass wont resize properly is my guess.

The rifle functions fine tho and nothing is broken.... if the bolt is closed, it gonna go bang!

DASHZNT
DASHZNT is offline  
 
Page generated in 0.04114 seconds with 7 queries