View Single Post
Old November 24, 2012, 05:35 PM   #8
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 10,247
I got two of their Garand barrels made from Douglas blanks through Brownells a number of years ago. Should have been good based on the blank quality, but the breech end contour was 0.005" over maximum spec from the shoulder and you could not close a bolt on them. The breech end of the roughed chamber was wider than my pull-through reamer, which portended short brass life. So if you get one, check its dimensions carefully for setup errors.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
 
Page generated in 0.04414 seconds with 7 queries