View Single Post
Old November 23, 2012, 11:55 PM   #1
stevenrs1
Junior Member
 
Join Date: May 7, 2009
Location: Southern California
Posts: 6
Advice repairing Remington 870

I noticed while disassembling my 870 that the locking block fell out. I know that it shouldn't and on closer inpection noticed a hole in the side of the locking block. After consulting a parts diagram I found that the locking block stud was missing. I ordered one and have it in hand. My question is does it just push it into the hole (it does fit fairly snugly) or should I use loctite or anythig else to hold it in? Any advice from someone with knowledge would be appreciated. I do realize that in order to reinstall the locking block after the new stud is in that I will have to remove the firing pin and install it from the bottom of the breech bolt.
stevenrs1 is offline  
 
Page generated in 0.03967 seconds with 7 queries