View Single Post
Old November 21, 2012, 08:51 PM   #5
SEHunter
Senior Member
 
Join Date: October 6, 2009
Posts: 221
I just used the sizer die for the first time. I am still making adjustments in the attempt to get my correct head space but i noticed you can visually see where the bushing sized down the neck but it only appears to have sized about half the length of the neck. Is this normal?

I have the die about 7/8 of a turn up from the shell holder. Is it possible that the die is supposed to be screwed in further? My headspace measurement is the same now as before i sized. At first, i thought i just got lucky and had the die set just right to return the original once fired headspace measurement, but im not sure if thats whats happening or if the case body has even been sized yet?
SEHunter is offline  
 
Page generated in 0.04622 seconds with 7 queries