View Single Post
Old November 20, 2012, 11:10 PM   #10
medalguy
Senior Member
 
Join Date: August 31, 2009
Location: New Mexico
Posts: 1,017
If you're working with milsurp mags, I would fully disassemble them one at a time and wipe everything down with mineral spirits, dry with a clean towel, and reassemble. I say one at a time because often the parts won't fully interchange between mags. This way you don't have any issues with this. Wipe the outside only with a very light coat of oil, something like CLP, and again wipe until nearly dry. I don't use any oil on the inside because it simply holds dirt.
medalguy is offline  
 
Page generated in 0.04654 seconds with 7 queries