View Single Post
Old November 20, 2012, 04:29 PM   #1
breakingcontact
Junior member
 
Join Date: October 25, 2012
Location: Austin, TX
Posts: 736
930 SPX forend fit

I'm not able to fully thread the mag extension on as only 5 of the 6 threads on the magazine tube are exposed.

I need to figure out where the forend actually makes contact with the metal on the gun and shave off about 1/8th of an inch.

I can either do this inside or modify the outside (front) of the stock where the mag extension meets so the mag extension has a recess to come down another 1/8".

What do you think? Where do I trim?

Yes, I've tried forcing it down farther, checked everything, jiggled and wiggled.
breakingcontact is offline  
 
Page generated in 0.04678 seconds with 7 queries