Thread: Colt Python R2
View Single Post
Old November 19, 2012, 06:25 PM   #9
laytonj1
Senior Member
 
Join Date: June 1, 2005
Location: Alabama
Posts: 3,476
Hmmm.

I'm stumped, hard to tell from the pic but if it was stamped after it left the factory the finish would be displaced and you would see some bare metal. If it was stamped before the finish then it was either by the factory or it's been refinished.
At this point I would ask over on the Colt forum.
http://www.coltforum.com/

Jim
laytonj1 is offline  
 
Page generated in 0.04000 seconds with 7 queries