View Single Post
Old November 18, 2012, 04:26 PM   #1
Dragline45
Senior Member
 
Join Date: November 30, 2010
Posts: 2,422
Chambering A Round By Hand, Bad for Extractor?

Recently I have been noticing bullet setback with my Sig 232 and figured chambering the first round by hand with the slide locked back would minimize this. Upon further research I noticed some say this puts excess wear on the extractor since it has to slide over the back of the case? I read this on another forum so I am not sure of the validity of his comment, but would it be good practice to manually chamber the first round to minimize setback or does it really put excess strain on the extractor.

Last edited by Dragline45; November 18, 2012 at 04:42 PM.
Dragline45 is offline  
 
Page generated in 0.04158 seconds with 7 queries