View Single Post
Old November 18, 2012, 11:40 AM   #5
oneoldsap
Senior Member
 
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,588
Uniformity

I didn't see anywhere where you trimmed all brass to the same length . It's important to have all brass the same length , when neck sizing . I usually trim brass that I'm going to neck size , .010" shorter than recommended trim to length in the manuals . Depending on a few variables , you should be able to get 5-10 reloads before needing to trim again !
oneoldsap is offline  
 
Page generated in 0.04017 seconds with 7 queries