View Single Post
Old November 17, 2012, 01:33 PM   #17
Senior Member
Join Date: February 9, 2006
Location: Homes in Brooklyn, NY and in Pennsylvania.
Posts: 4,330

How did the 'firing pin nail" get out of the gun? Did the pierced primer blow the gun apart?
Questions that I was asking myself. I am having a hard time with the concept, that the bogus pin could make it past the hammer, that there was enough pressure bled off to cause this to happen and that the pressure could be maintained after escaping the primer hole, entering the FP hole and then expanding inside the rear of the slide, blowing out the FP stop....with a bullet going out the other end. Trouble imagining the physics of it all.
"Only hunting and mountain climbing are sports. The rest are just games." - R.Ruark
NRA Life Member
darkgael is offline  
Page generated in 0.04540 seconds with 7 queries